Search results

Jump to navigation Jump to search

Page title matches

  • ...heet/pine64/A64_Datasheet_V1.1.pdf Allwinner A64 Datasheet] section '''4.2 GPIO Multiplexing Functions''' and section '''4.3 Detailed Pin/Signal Descriptio
    13 KB (1,905 words) - 11:22, 1 February 2023
  • == GPIO Header Pin Table == ! Pin !! Name !! Physical Pin (Designation) !! Linux GPIO !! Alternate Func 1 !! Alternate Func 2 !! Interrupt
    2 KB (186 words) - 09:20, 18 October 2020

Page text matches

  • == GPIO Header Pin Table == ! Pin !! Name !! Physical Pin (Designation) !! Linux GPIO !! Alternate Func 1 !! Alternate Func 2 !! Interrupt
    2 KB (186 words) - 09:20, 18 October 2020
  • ...64's I2C bus that's exposed to the pin headers, and declare that a PCF8574 GPIO extender is hanging off it. gpio-controller;
    3 KB (557 words) - 15:00, 29 December 2021
  • ...ining it with 8 PCF8574A modules will actually push this to a total of 128 GPIO outputs added to your board! gpio-controller;
    9 KB (1,418 words) - 21:39, 2 April 2023
  • * [[SOPine_GPIO_Alternate_Functions_Table|SOPine GPIO Alternate Functions Table]] ...heet/pine64/A64_Datasheet_V1.1.pdf Allwinner A64 Datasheet] section '''4.2 GPIO Multiplexing Functions''' and section '''4.3 Detailed Pin/Signal Descriptio
    25 KB (3,281 words) - 16:47, 30 September 2023
  • ...soft-PWM a suitable 25 kHz signal for the fan. The ROCK64 uses 3.3V on the GPIO pins, so you'll need to logic level convert it to 5V if you're using a 5V A
    3 KB (592 words) - 21:29, 2 April 2023
  • |GPIO71 (/sys/class/gpio/gpio71) |GPIO69 (/sys/class/gpio/gpio69)
    22 KB (3,173 words) - 15:38, 5 April 2023
  • ! Name/GPIO # Move ANX7688 ANX-V1.0 Regulator Enable (R1352) from DLDO1 to a GPIO
    10 KB (1,659 words) - 14:57, 26 April 2021
  • | GPIO Pin || JTAG Pin BL602 multiplexes four GPIO pins to provide the familiar JTAG lines. See the accompanying table for the
    14 KB (2,194 words) - 00:59, 11 May 2023
  • == Projects Utilising General Purpose Input/Output (GPIO) Pins == ! style="border: 1px solid black; padding: 5px; background: #efefef;" | GPIO Projects
    26 KB (3,803 words) - 18:31, 20 February 2023
  • * 28x GPIO (TBD) * 2x20 pins "Pi2" GPIO Header
    17 KB (2,286 words) - 13:59, 20 October 2023
  • ...s SPI NOR flash storage and the devkit's camera flash (heh) share the same GPIO pins. The flash storage may not be used. 4. On the camera flash GPIO conflict, the new assignment of GPIO PB3 pin for SGM3140 FLASH_EN and GPIP PD7 for FLASH_TRIGOUT. Please note th
    13 KB (1,945 words) - 20:24, 12 April 2023
  • * 2x20 pins "Pi2" GPIO Header * 2x17 pins "Euler" GPIO Header
    11 KB (1,592 words) - 08:43, 27 August 2023
  • * 2x20 pins "Pi2" GPIO Header
    3 KB (394 words) - 23:43, 8 April 2023
  • ** 26 pins GPIO port ** 5V 1A from MicroUSB Port or GPIO port
    16 KB (2,308 words) - 15:48, 3 September 2023
  • ...port, two USB 2.0 host ports, Gigabit Ethernet, a PI-2 GPIO bus, an Euler GPIO bus as well as many other peripheral device interfaces such as UART, SPI, a * 2x20 pins "Pi2" GPIO Header
    11 KB (1,637 words) - 15:04, 26 September 2023
  • ...r/dp/B077XPSKQD female terminal block] wire using breadboard wire into the GPIO block at the following locations in a "null modem" configuration with trans
    3 KB (509 words) - 10:43, 30 March 2023
  • All GPIO pins, including UART, operate at 3.3V. (See VCCIO5 in the schematics.) * 2x20 pins "Pi2" GPIO Header
    18 KB (2,627 words) - 08:07, 23 October 2023
  • ! scope="row" | GPIO | <code>gpio-rockchip</code>
    21 KB (3,171 words) - 14:48, 8 October 2023
  • * 2x20 pins "Pi2" GPIO Header * 2x17 pins "Euler" GPIO Header
    14 KB (2,141 words) - 06:18, 8 November 2023
  • ...modem can wake up the A64 (for incoming calls and text messages). The only GPIO bank that can receive interrupts while the A64 is suspended is Port L (on < ...powering always-on 3v3 from DCDC1, video-related 3v3 from DLDO1, 1v8 from GPIO-LDO1, and 1v0 controlled by PD11.''
    14 KB (2,411 words) - 15:20, 27 February 2023
  • * 2&times;20 pins "Pi2" GPIO Header ** The JH7110 SoC supports full multiplexing of its GPIO pins. This means any non-power/ground pin can be configured to any function
    12 KB (2,038 words) - 08:20, 19 December 2023
  • ...DMI, power and audio jack port side, and only tightening the screws on the GPIO side to still make good ground contact. The HDMI and audio jacks should the
    4 KB (747 words) - 13:17, 5 February 2023
  • * GPIO pins exposed for each SOPINE module, including the UARTs To boot use the serial console connect the pins to UART0 on the GPIO header and connect using baud 115200
    12 KB (1,868 words) - 05:49, 1 November 2023
  • * 26 GPIO pins, including SPI, I<sup>2</sup>C and UART functionality, possible I<sup> UART TX is physical pin 1/GPIO 14.
    20 KB (3,069 words) - 03:43, 19 January 2024
  • ...1x USB 3.0 Type-A host, 3x USB 2.0 host, Gigabit Ethernet, SATA (model A), GPIO Bus, MiPi DSI interface, e-ink interface (model A), eDP interface (model A) * 2x20 pins "Pi2" GPIO Header on model B, 2x10 pins GPO header on model A
    30 KB (4,439 words) - 07:56, 14 November 2023
  • * 5V power rails on the 20 pin GPIO header
    5 KB (685 words) - 22:04, 2 April 2023
  • System Serial is located on PI-5 bus (11x2 GPIO header).
    7 KB (1,040 words) - 08:41, 12 April 2023
  • * Changed GPIO assignment so more functionality is available (i.e. NFC and VSYNC)
    5 KB (760 words) - 00:49, 16 March 2023
  • ...1x USB 3.0 Type-A host port, 2x USB 2.0 host port, Gigabit Ethernet, PI-2 GPIO bus, MiPi DSI interface, eDP interface, touch panel interface, stereo MiPi * 2x20 pins "Pi2" GPIO header
    34 KB (4,719 words) - 04:41, 18 November 2023
  • * 2x20 pins "Pi2" GPIO Header
    8 KB (1,124 words) - 20:15, 3 April 2023
  • * [[SOPine GPIO Alternate Functions Table]]
    8 KB (1,243 words) - 06:55, 1 November 2023
  • XH 6 2.54mm pitch connector for GPIO/SPI/PWM output
    8 KB (1,326 words) - 16:13, 24 April 2023
  • ...ocs/pine64/index.html Good documentation about PINE A64, A64+, and A64-LTS GPIO pins article]
    11 KB (1,609 words) - 01:06, 16 March 2023
  • *** Enable the usermode access for all unusable GPIO pins in Pi-2 bus( later provide a UWP sample to show how to control these p
    12 KB (1,817 words) - 15:03, 26 September 2023
  • ...heet/pine64/A64_Datasheet_V1.1.pdf Allwinner A64 Datasheet] section '''4.2 GPIO Multiplexing Functions''' and section '''4.3 Detailed Pin/Signal Descriptio
    13 KB (1,905 words) - 11:22, 1 February 2023
  • ...of the case so that it can easily be routed to its header located next to GPIO pins on the STAR64.
    13 KB (2,292 words) - 19:57, 1 August 2023
  • ! scope="row" | GPIO | <code>rockchip-gpio</code>
    27 KB (4,027 words) - 08:01, 14 November 2023
  • ...of the case so that it can easily be routed to its header located next to GPIO pins on the ROCKPro64.
    13 KB (2,282 words) - 17:49, 20 February 2023
  • ...ble by reading the I2C registers of the WUSB3801Q. So connecting ASEL to a GPIO would be enough to get this working if it is not working already.
    16 KB (2,333 words) - 02:20, 14 October 2023
  • ...roduct/pinecil-break-out-board/ Pinecil breakout board] lets you use JTAG, GPIO, A2D, SPI, and more. ...ill uses a RISC-V processor, but adds noticeable upgrades to the hardware. GPIO is broken out on USB-C for creating your own projects, same pinout as Pinec
    43 KB (6,767 words) - 18:02, 12 December 2023
  • ...pine64.org/doc/PineTime/PineTime%20Port%20Assignment%20rev1.0.pdf PineTime GPIO Port Assignment ver1.0]
    21 KB (3,119 words) - 11:27, 13 January 2024
  • ...Braam> can't the rk3599 detect the debug attachment condition and toggle a gpio to control a simple mux?
    24 KB (3,830 words) - 21:12, 12 January 2023