User:Silver/3d printed a folding keyboard mostly
Jump to navigation
Jump to search
Current status
You cannot type on this yet.
Stuff
rev9aback.stl is a model that should screw nicely to the back of a pinephone and replaces it's stock frame.
the rev10 files include a folding mechanism with a cable passage. Currently looking for feedback for problems on this one before I do rev 11.
https://www.youmagine.com/designs/pinephone-folding-keyboard-mockup
Development updates
rev 10 problems
Looking for confirmation and suggestions on solutions for these issues with rev 10 that I would like to fix in 11
- Base layer too thin on lid: fixed
- Base layer too thick on phone side: fixed
- doesn't have a reset button hole
- lid is flimsy, could use a thicker wall
- still need side buttons worked out
- hinge gaps are all wrong
- hinge should rest on a hingepin not on the cable passage cup faces
- maybe include a washer or two in the hinge
- camera hole is really ugly
- headphone jack is weak
- charger hole is ugly
- need to decide on an actual size if using nuts and bolts
- bumps for holding angle should be deeper
- screw holes for pinephone might be too big?
- lid screwholes are not very useful. Maybe posts?