Current status

You cannot type on this yet.

Stuff

rev9aback.stl is a model that should screw nicely to the back of a pinephone and replaces it's stock frame.

the rev10 files include a folding mechanism with a cable passage. Currently looking for feedback for problems on this one before I do rev 11.

Base layer too thin on lid: fixed

Base layer too thick on phone side: fixed

doesn't have a reset button hole

lid is flimsy, could use a thicker wall

still need side buttons worked out

hinge gaps are all wrong

hinge should rest on a hingepin not on the cable passage cup faces

maybe include a washer or two in the hinge

camera hole is really ugly

headphone jack is weak

charger hole is ugly

need to decide on an actual size if using nuts and bolts

bumps for holding angle should be deeper

screw holes for pinephone might be too big?

lid screwholes are not very useful. Maybe posts?