Changes

Jump to navigation Jump to search
no edit summary
= Errata for ver1.1 and ver1.2 board =
'''1. Please DON'T insert micro SIM card to dev kit board micro SIM card slot, the SIM data, VPP, and GND signal have been misplaced. A miciPCIe adapter with sim card holder 9shown as below photo) will be provide to developers to correct this mistake.''' [[File:MiniPCIe_with_sim_slot_adapter.png]]  '''2. The PinePhone dev kit doesn't charge due to VBUS on SOPine module is not connected. Please connect R9688 solder pads with 0 ohm resistor or using thin wire bridge up the solder pads. Location shows as below:'''
[[File:PinePhone_VBUS_charging_small.png]]
'''3. The SOPINE's SPI NOR flash storage and the devkit's camera flash (heh) share the same GPIO pins. The flash storage may not be used.'''
[[File:SOPINE-SPI-Flash.png]] [[File:Pinephone-1.1-flash-schematic.png]]
On the camera flash GPIO conflict, the new assignment of GPIO PB3 pin for SGM3140 FLASH_EN and GPIP PD7 for FLASH_TRIGOUT. Please note that PD7 is also LCD_ID pin which may not be used.
'''4. On the camera flash GPIO conflict, the new assignment of GPIO PB3 pin for SGM3140 FLASH_EN and GPIP PD7 for FLASH_TRIGOUT. Please note that PD7 is also LCD_ID pin which may not be used.'''
[[File:GPIO_PB3_location.jpg]]

Navigation menu