Changes

Jump to navigation Jump to search
no edit summary
= Errata for ver1.1 and ver1.2 board =
The PinePhone doesn't charge due to VBUS on SOPine module is not connected. Please connect R9688 solder pads with 0 ohm resistor or using thin wire bridge up the solder pads. Location shows as below:
[[File:SOPINE-SPI-Flash.png]] [[File:Pinephone-1.1-flash-schematic.png]]
 
On the camera flash GPIO conflict, the new assignment of GPIO PB3 pin for SGM3140 FLASH_EN and GPIP PD7 for FLASH_TRIGOUT. Please note that PD7 is also LCD_ID pin which may not be used.

Navigation menu