Changes

Jump to navigation Jump to search
no edit summary
= Errata =
The single USB Type-C port defaults PinePhone doesn't charge due to "USB Host" (including when VBUS on SOPine module is not connected. Please connect R9688 solder pads with 0 ohm resistor or using thin wire bridge up the device is off)solder pads. The device will not charge when it is in USB Host modeLocation shows as below: [[File:PinePhone_VBUS_charging_small.png]] 
The SOPINE's SPI NOR flash storage and the devkit's camera flash (heh) share the same GPIO pins. The flash storage may not be used.

Navigation menu