Difference between revisions of "Wifi Remote I2c"
Jump to navigation
Jump to search
| Line 16: | Line 16: | ||
* Once Termite configuration is done, press 'OK' to save the setting. | * Once Termite configuration is done, press 'OK' to save the setting. | ||
* On the Wifi Remote I2c Device, Press the configuration button to allow the device to go into configuration mode. | * On the Wifi Remote I2c Device, Press the configuration button to allow the device to go into configuration mode. | ||
[[File:Wr_Config_Mode_Sw.jpg| | [[File:Wr_Config_Mode_Sw.jpg|frameless|caption]] | ||
* | Press Config Mode button to go into configuration mode | ||
* Type 'help' to show the command available for configuration. | |||
* Type 'show' to list out current configuration. | |||
* To Set the PineA64 IP address in to the device, enter (we will be using IP address 192.168.0.230 as example) | * To Set the PineA64 IP address in to the device, enter (we will be using IP address 192.168.0.230 as example) | ||
server 192.168.0.230 | |||
* To configure the Wifi AP SSID and Password, (eg SSID=TestingWifi and Password=12345 ) | * To configure the Wifi AP SSID and Password, (eg SSID=TestingWifi and Password=12345 ) | ||
wifi TestingWifi 12345 | |||
* The SSID and password are case sensitive. Please make sure it is input correctly. | * The SSID and password are case sensitive. Please make sure it is input correctly. | ||
* Once configuration is done, type 'exit' to exit configuration mode and allow the device to reboot. | * Once configuration is done, type 'exit' to exit configuration mode and allow the device to reboot. | ||
== Download == | == Download == | ||
Revision as of 04:48, 14 May 2016
Quick Start Guide
Hardware Setup
- Make sure that the driver for USB/UART Programming/Console Adapter (PMPROG01) is properly install and the PC is detected it as Comm Port.
- The USB/UART Bridge is base on Silicon Lab CP2012 chipset.
- USB/UART Programming/Console Adapter (PMPROG01) driver can be Download here
- Connect the USB/UART Programming/Console Adapter (PMPROG01) to the Wifi Remote I2c Device.
Setting Configuration
- For windows system, you can use terminal emulator program Termite to configure the device.
- Termite can be downloaded at http://www.compuphase.com/software_termite.htm
- Make sure the 'Port' setting is refer to the USB/UART Programming/Console Adapter (PMPROG01)'s Comm Port.
- Follow the setting according to the setup screen capture
- Once Termite configuration is done, press 'OK' to save the setting.
- On the Wifi Remote I2c Device, Press the configuration button to allow the device to go into configuration mode.
Press Config Mode button to go into configuration mode
- Type 'help' to show the command available for configuration.
- Type 'show' to list out current configuration.
- To Set the PineA64 IP address in to the device, enter (we will be using IP address 192.168.0.230 as example)
server 192.168.0.230
- To configure the Wifi AP SSID and Password, (eg SSID=TestingWifi and Password=12345 )
wifi TestingWifi 12345
- The SSID and password are case sensitive. Please make sure it is input correctly.
- Once configuration is done, type 'exit' to exit configuration mode and allow the device to reboot.