Difference between revisions of "ROCKPro64"
Jump to navigation
Jump to search
Line 887: | Line 887: | ||
* To allow enough clearance between the board and the bracket you either need to print four copies of the washer model or add nut(s) between the board and the bracket | * To allow enough clearance between the board and the bracket you either need to print four copies of the washer model or add nut(s) between the board and the bracket | ||
* If using nuts for the clearance between the board and the brackets, make sure it creates at least 3.2mm of spacing in between | * If using nuts for the clearance between the board and the brackets, make sure it creates at least 3.2mm of spacing in between | ||
* Depending on the accuracy and calibration of a 3D printer, slight deviation can occur and you likely need to manually widen some of the holes to allow screws to fit | |||
= Other Resources = | = Other Resources = |