Difference between revisions of "ROCK64 Premium Aluminum Casing"
Jump to navigation
Jump to search
| Line 19: | Line 19: | ||
=== Plastic Pegs for PWR and RST Buttons === | === Plastic Pegs for PWR and RST Buttons === | ||
If you are tired of using a pen or a toothpick to push the buttons, there are 3d-printable plastic pegs you can download | If you are tired of using a pen or a toothpick to push the buttons, there are [[Media:Button.zip|3d-printable plastic pegs you can download]] and print yourself. Recommended material is PLA, excellent results can be obtained using a 0.25mm nozzle, though slightly larger sizes should work fine as well. | ||
To use the pegs, open your case and remove the ROCK64 from within. Be sure to pull out the light guide and rubber plug to remove it, or else it will catch on them. Once it is removed, turn your bottom half of the case such that the holes for PWR and RST are pointing towards the floor, and drop the pegs into the holes from inside the case, so that the lip prevents them from falling through. Hold them in position with your finger, turn the case the right side up again, and reinstall your ROCK64. | To use the pegs, open your case and remove the ROCK64 from within. Be sure to pull out the light guide and rubber plug to remove it, or else it will catch on them. Once it is removed, turn your bottom half of the case such that the holes for PWR and RST are pointing towards the floor, and drop the pegs into the holes from inside the case, so that the lip prevents them from falling through. Hold them in position with your finger, turn the case the right side up again, and reinstall your ROCK64. | ||