Difference between revisions of "Pinecil"
Jump to navigation
Jump to search
m Tag: Manual revert |
|||
Line 193: | Line 193: | ||
== Disassembly steps == | == Disassembly steps == | ||
# Remove | # Recommend to take photos to help with reassembly. | ||
# Remove the Tip. | |||
# Let tip cool down. | |||
# Loosen the top tip screw (PH1) (top is display screen side). | |||
# Slide rubber off towards the tip side. | # Gently pull the tip out and set aside. | ||
# Remove the | # Slide rubber thumb grip off towards the tip side. | ||
# Remove the | # Remove the bottom screw (at the tip, between the feet) (PH1). | ||
# Slightly pull the two halves of the case apart at the tip | # Remove the ground screw (longer screw on the top side near the (-) button) (PH1). | ||
# Slightly pull the two halves of the case apart at the tip front end, enough to get a fingernail or guitar pick between the halves. | |||
# Move the pick down the length of the split to loosen the bottom half's clips from the top half of the case. | # Move the pick down the length of the split to loosen the bottom half's clips from the top half of the case. | ||
# Once loose, remove the bottom half by moving it forward (it is retained by the top half at the port side). | # Once loose, remove the bottom half by moving it forward (it is retained by the top half at the port side). | ||
# Remove the screws retaining the copper tip contacts (PH000, M1.4 x 5). | # Remove the screws retaining the copper tip contacts (PH000, M1.4 x 5), and note the direction. | ||
# Remove the | # Remove the copper tip contacts. | ||
# | # Flip the Pinecil over and the PCB should fall out, or it could be lifted gently up from the DC barrel end. | ||
# The two small buttons are now loose, carefully set aside the top half, or remove the buttons so they do not get lost. | |||
'''Alternate method for opening the Pinecil V1 or V2 [https://www.youtube.com/watch?v=aK01V5DrrVk shown in this video:]''' | |||
== Assembly steps == | == Assembly steps == |