Difference between revisions of "PineNote"
Jump to navigation
Jump to search
(Added link to Android SDK for RK3566 page) |
|||
| Line 138: | Line 138: | ||
* '''Could the USB-C port support USB 3.1 5Gbps?''' Yes and no. The RK3566 only has a host-mode 5Gbps controller, meaning it can only negotiate such a high data rate with a device such as a flash drive. When the RK3566 is acting as a device, it only supports 480Mbps transfer rates. The hardware required to switch between these modes would raise the PineNote's price unreasonably. Therefore, the USB-C port will remain at USB 2.0 speeds for Host and Device mode. | * '''Could the USB-C port support USB 3.1 5Gbps?''' Yes and no. The RK3566 only has a host-mode 5Gbps controller, meaning it can only negotiate such a high data rate with a device such as a flash drive. When the RK3566 is acting as a device, it only supports 480Mbps transfer rates. The hardware required to switch between these modes would raise the PineNote's price unreasonably. Therefore, the USB-C port will remain at USB 2.0 speeds for Host and Device mode. | ||
* '''Could the USB-C port output DisplayPort?''' Yes and no. The hardware required to support such a feature would raise the PineNote's price unreasonably. Therefore, DisplayPort output will not be possible through the USB-C port. | * '''Could the USB-C port output DisplayPort?''' Yes and no. The hardware required to support such a feature would raise the PineNote's price unreasonably. Therefore, DisplayPort output will not be possible through the USB-C port. | ||
* '''Where is the microSD card slot?''' The case design of the PineNote is fixed, making physical changes like adding a microSD card slot would raise the cost unreasonably | * '''Where is the microSD card slot?''' The case design of the PineNote is fixed, making physical changes like adding a microSD card slot would raise the cost unreasonably. | ||
* '''How will I install software to the PineNote?''' This is a hardware and software question. If the software on your PineNote is completely broken and cannot boot to a recoverable state, a Hall (magnet) sensor was fitted to the PineTab motherboard as U9009. This sensor is attached to SARADC_VIN0_KEY/RECOVERY on the RK3566. With the device powered off, and screen face down, holding a magnet over U9009 and plugging in a USB-C cable causes the device to boot into [http://opensource.rock-chips.com/wiki_Rockusb|"rockusb"] flash mode. With proper flashing software and drivers, it should be possible to load a new operating system using rockusb if the system is soft-bricked. Of course, software vendors will need to be more careful with flashing firmware and providing useful "recovery" options on this device due to this process's relative difficulty to other PINE64 devices. | * '''How will I install software to the PineNote?''' This is a hardware and software question. If the software on your PineNote is completely broken and cannot boot to a recoverable state, a Hall (magnet) sensor was fitted to the PineTab motherboard as U9009. This sensor is attached to SARADC_VIN0_KEY/RECOVERY on the RK3566. With the device powered off, and screen face down, holding a magnet over U9009 and plugging in a USB-C cable causes the device to boot into [http://opensource.rock-chips.com/wiki_Rockusb|"rockusb"] flash mode. With proper flashing software and drivers, it should be possible to load a new operating system using rockusb if the system is soft-bricked. Of course, software vendors will need to be more careful with flashing firmware and providing useful "recovery" options on this device due to this process's relative difficulty to other PINE64 devices. | ||