Difference between revisions of "PineNote"
Jump to navigation
Jump to search
m (→Hardware) |
Aarondabomb (talk | contribs) |
||
| Line 167: | Line 167: | ||
==== USB-C Debug Accesory Mode (DAM)/UART Dongle==== | ==== USB-C Debug Accesory Mode (DAM)/UART Dongle==== | ||
The USB UART dongle delivered with the PineNote allows you to have access to a serial port without having to open up the device. The factory firmware runs at a baud rate of 1500000bps, 8 data bits 1 stop bit, no parity and no flow control. The USB-C male end should go into the PineNote and the female end can be connected with a standard USB-C cable to your computer. | The USB UART dongle delivered with the PineNote allows you to have access to a serial port without having to open up the device. The factory firmware runs at a baud rate of 1500000bps, 8 data bits 1 stop bit, no parity and no flow control. The USB-C male end should go into the PineNote and the female end can be connected with a standard USB-C cable to your computer. | ||
=== Documentation === | |||
PineNote development documentation is a little lacking. Unless you are relatively plugged in with the chat, it's difficult to know what is going on. There is an effort to amend that that lives here: [[PineNote/Documentation]]. | |||
== BSP Linux SDK == | == BSP Linux SDK == | ||