Difference between revisions of "PineNote"

Jump to navigation Jump to search
Line 153: Line 153:
* '''Could the USB-C port output DisplayPort?''' Yes and no. The hardware required to support such a feature would raise the PineNote's price unreasonably. Therefore, DisplayPort output will not be possible through the USB-C port.
* '''Could the USB-C port output DisplayPort?''' Yes and no. The hardware required to support such a feature would raise the PineNote's price unreasonably. Therefore, DisplayPort output will not be possible through the USB-C port.
* '''Where is the microSD card slot?''' The case design of the PineNote is fixed, making physical changes like adding a microSD card slot would raise the cost unreasonably.
* '''Where is the microSD card slot?''' The case design of the PineNote is fixed, making physical changes like adding a microSD card slot would raise the cost unreasonably.
* '''How will I install software to the PineNote?''' This is a hardware and software question. If the software on your PineNote is completely broken and cannot boot to a recoverable state, a Hall (magnet) sensor was fitted to the PineTab motherboard as U9009. This sensor is attached to SARADC_VIN0_KEY/RECOVERY on the RK3566. With the device powered off, and screen face down, holding a magnet over U9009 and plugging in a USB-C cable causes the device to boot into [http://opensource.rock-chips.com/wiki_Rockusb|"rockusb"] flash mode. With proper flashing software and drivers, it should be possible to load a new operating system using rockusb if the system is soft-bricked. Of course, software vendors will need to be more careful with flashing firmware and providing useful "recovery" options on this device due to this process's relative difficulty to other PINE64 devices.
* '''How will I install software to the PineNote?''' This is a hardware and software question. If the software on your PineNote is completely broken and cannot boot to a recoverable state, a Hall (magnet) sensor was fitted to the PineTab motherboard as U9009. This sensor is attached to SARADC_VIN0_KEY/RECOVERY on the RK3566. With the device powered off, and screen face down, holding a magnet over U9009 and plugging in a USB-C cable causes the device to boot into [http://opensource.rock-chips.com/wiki_Rockusb "rockusb"] flash mode. With proper flashing software and drivers, it should be possible to load a new operating system using rockusb if the system is soft-bricked. Of course, software vendors will need to be more careful with flashing firmware and providing useful "recovery" options on this device due to this process's relative difficulty to other PINE64 devices.


==== Unresolved ====
==== Unresolved ====
Retrieved from "https://wiki.pine64.org/wiki/PineNote"