The following is documentation for a proposed Pine64 product by the community and is not an official Pine64 product. This content is the result of initial discussions about this device documented in the forum.
Join us for discussion in IRC.
The aim of this project is to create a Pine64 open source USB flash drive (hence the name PineFlash), that can act as the basis of future projects in this area. An open source flash device would allow the community to address storage information security (CIA). Additionally, issues such as speed and compatibility can also be addressed.
|Read speed||12Mbit/s (Full speed USB 1.x)||480Mbit/s (High speed USB 2.0)|
|Write speed||12Mbit/s (Full speed USB 1.x)||480Mbit/s (High speed USB 2.0)|
TODO Document the plan for development of this device.
This is the documentation of the initial prototype design.
The initial prototype is to be a 'hat' for the community driven Nutcracker project, specifically the BL602. The controller is RISC-V (as the final controller is planned to be) and supports quad-SPI.
TODO The proposed schematic for the device.
TODO The bill of materials used in the schematic.
TODO The PCB design for the device.
TODO Document the prototype's software stack.
TODO Figure out exactly how the prototype will be tested to ensure robustness and performance.
- Type A & Type C USB interfaces (barray)
- RAID (barray)
- Dynamically adjusted wear leveling pool (Arwen)
- USB attached SCSI, (aka UASP) (Arwen)
- Fingerprint scanner (Julius_GU)
- Lit Pine logo on casing (Julius_GU)