Difference between revisions of "NASCase"

Jump to navigation Jump to search
Line 148: Line 148:
Installing the HDD/SSD bracket into the case and wiring it up is the last step before closing up the case.  
Installing the HDD/SSD bracket into the case and wiring it up is the last step before closing up the case.  


Place the bracket with the disks installed in the case. The bracket should line up with the guiding bolts and screw holes at the bottom of the case. The section of the bracket that holds 3.5” HDDs needs to face the left side of the case (when viewed from front) and should overhang the ROCKPro64 board slightly. The 3.5” SATA and power ports should face the right side of the case - where the fan mounts, while 2.5” SATA and power ports should face the front of the case.  
Place the bracket with the disks installed (from step 4) into the case. The bracket should line up with the guiding bolts and screw holes at the bottom of the case. The section of the bracket that holds 3.5” HDDs needs to face the left side of the case (when viewed from front) and should overhang the ROCKPro64 board slightly. The 3.5” SATA and power ports should face the right side of the case - where the fan mounts, while 2.5” SATA and power ports should face the front of the case.  


With the bracket aligned, flip the bottom of the case over while holding the bracket in place. Screw it into place using 4x phillips head screws that came included with the NAS Case.  
With the bracket aligned, flip the bottom of the case over while holding the bracket in place. Screw it into place using 4x Phillips head screws that came included with the NAS Case.  


The last thing remaining before the NAS Case can be screwed shut is routing SATA and power cables:  
The last thing remaining before the NAS Case can be screwed shut is routing SATA and power cables: