PinePhone Power Management

The data on this page is based on the the PinePhone v1.1 - Braveheart.

Regulators

Current Assignment
Name/GPIO	Output Voltage	Disable at runtime?	Disable in suspend?	Uses
DCDC1	3.3V	No	No (PWRKEY?, VCC-IO?)	VCC-EFUSE, VCC-IO, VCC-PC (VQMMC2), VCC-PD, VCC-USB; Modem I2C/PCM/UART, Modem PWRKEY?, Motor, Pogo I2C, UART0, VMMC0, VMMC2, WiFi CHIP_EN,
DCDC2	1.0-1.3V (DVFS)	No	Yes	VDD-CPUX
DCDC3	N/A	N/A	N/A	VDD-CPUX (polyphase with DCDC2)
DCDC4	N/A	Yes	Yes	Not used
DCDC5	1.2V	No	Yes (future)	VCC-DRAM; DRAM
DCDC6	1.1V	No	Yes (future)	VDD-SYS
DC1SW	N/A	Yes	Yes	Not used
ALDO1	2.8V	Yes	Yes	VCC-PE; Camera AFVCC, Camera DOVDD, CSI I2C, Pogo I2C
ALDO2	1.8V	No	No	VCC-PL; Pogo INT
ALDO3	3.0V	No	Yes (future)	AVCC, KEYADC, VCC-PLL
DLDO1	3.3V	No (ANX7688 [AVDD33, VCONN_EN Disable Pull-up])	No	HVCC, VCC-DSI; ANX7688 [AVDD33, HDMI_VT, I2C, VDD1V0 Enable, VCONN_EN Disable Pull-up], HDMI [DDC, HPD], Proximity LED, Sensor I2C, Sensor VDD
DLDO2	1.8V	Yes	Yes	MIPI-DSI VIO
DLDO3	2.8V	Yes	Yes	Camera AVDD
DLDO4	3.3V	Yes	Yes	VCC-PG; VQMMC1
ELDO1	1.8V	No	No (DRAM)	CPVDD; DRAM
ELDO2	N/A	Yes	Yes	Not used
ELDO3	1.8V	Yes	Yes	Camera DVDD
FLDO1	1.2V	Yes	Yes	HSIC-VCC (not used)
FLDO2	1.1V	No	No (VDD-CPUS)	VDD-CPUS
GPIO0-LDO	3.3V	Yes	Yes	ANX7688 I2C, Backlight, LCD, Proximity sensor, Touchscreen [I2C, VCC]
GPIO1-LDO	1.8V	No (ANX7688 DVDD1V8)	No (ANX7688 DVDD1V8)	ANX7688 [AVDD1V8, DVDD1V8, CC, HDMI DDC, I2C, Power/Reset pull-up]
PD6	5.0V	Yes	Yes	USB OTG
PD8	5.0V	Yes	Yes	Pogo supply, USB OTG via PD6
PD9	5.0V	Yes	Yes	VCONN (USB Type C)
PH10	PWM	Yes	Yes	Backlight
PL7	VBAT	Yes	Yes	Modem
ANX-V1.0	1.0V	Yes	Yes	ANX7688 [AVDD1V0, DVDD1V0]