Pinebook Pro Hardware Accessory Compatibility
Jump to navigation
Jump to search
Pinebook Pro accessories - by type
This page was started in the early days when not all accessories/peripherals were working.
NVMe SSD drives
Note that only PCIe type M.2 drives will work. Any SATA or USB type M.2 card will NOT work.
Type | Make/Model | Size | Hardware IDs | Result | Notes | Power options Active only |
Save power setting? | |
---|---|---|---|---|---|---|---|---|
2242 | Toshiba OCZ RC 100 | 240 GB | RC100-M22242-240G | good | ||||
2242 | Lexar NM520 | 256 GB | LNM520-256RBNA | good | PS 0: 3.05W PS 1: 2.44W PS 2: 2.02W |
No. See workaround. | ||
2280 | XPS SX8200 | 512 GB | ASX8200PNP-512GT-C | good | Performed these steps for physical installation. Currently rooting from drive. | |||
2280 | Intel 660p M.2 | 512 GB | SSDPEKNW512G8X1 | good | PS 1 (2.70W) will work without issues, even under heavy load. Recommended over PS 2, as PS 2 will incur an additional 80% performance penalty. APSTE shows enabled but drive does not support it. | No | ||
2280 | Intel 660p M.2 | 1 TB | SSDPEKNW010T8X1 | good | PS 0: 4.00W PS 1: 3.00W PS 2: 2.20W APSTE Disabled by default |
No | ||
2280 | Samsung 970 EVO Plus | 250 GB | MZ-V7S250BW | fail | Tested on Manjaro-ARM as root drive. Limited to PS 2 and Volatile Write Cache off gives the most stable results, but it will still hang on a hdparm test. | |||
2280 | Samsung 970 EVO Plus | 500 GB | MZ-V7S500 | fail | Too power hungry? | PS 0: 6.2W PS 1: 4.3W PS 2: 2.1W |
||
2280 | Samsung 970 EVO | 1 TB | MZ-V7E1T0BW | fail | Too power hungry? | |||
2280 | Corsair MP300 | 120 GB | CSSD-F120GBMP300 | good | PS 0: 3.00W PS 1: 2.00W PS 2: 2.00W PS 3: 0.1W PS 4: 0.005W APSTE Disabled by default |
|||
2280 | Silicon Power P34A60 | 256 GB | ??? | fail | Isn't detected | |||
2280 | Sabrent Rocket | 256 GB | SB-ROCKET-256 | good | No | |||
2242 | Sabrent Rocket Nano | 512 GB | SB-1342-512 | good* | No touchpad issues, didn't trim NVME adapter board. (*Might be too power hungry. More testing needed.) |
|||
2280 | MyDigitalSSD SBXe | 960 GB | good | APST enabled Power states N/A |
N/A | |||
2280 | HP SSD EX900 | 250GB | good | No low-power modes available | ||||
2280 | WD BLUE SN550 | 1TB | WDC WDS100T2B0C-00PXH0 | good | Booted successfully from NVMe (Bionic MATE) | PS 0: 3.50W PS 1: 2.70W PS 2: 1.90W APSTE Disabled by default |
N/A | |
2280 | WD Blue SN500 | 500GB | WDS500G1B0C | fail | Works OK on power state 2 (2.5W), but hangs the system whenever there is intense IO (peak draw) on the drive | |||
2242 | WD PC SN520 | 256GB | - | fail | Power LED Flashes. Nothing else happens. | |||
2280 | WD BLACK SN750 | 250GB | WDS250G3X0C-00SJG0 | good | No touchpad issues, didn't trim NVME adapter board. | APSTE disabled by default PS 0: 5.00W PS 1: 3.50W PS 2: 3.00W |
||
2242 | KingSpec NE-512 | 512 GB | NE512 | good | APST enabled Power states N/A |
N/A |
USB hardware
Type | Make/Model | Hardware IDs | Result | Notes |
---|---|---|---|---|
USB-2 SDHC reader | Sandisk MobileMate+ | 0781:b2b3 | good | |
USB-3 SDHC/CF reader | Transcend TS-RDF8K | 8564:4000 | good | |
USB-C Hub | Totu 8-in-1 | 058f:8468, 2109:0817 USB3, 1a40:0801, 2109:2817 USB2, bda:8153 RTL8153 Gigabit Ethernet | Network, USB, Card Reader, Power Good, HDMI Not Working | Amazon Smile [1] |
USB-3 combo hub (network, card slots, usb ports) | generic | 05e3:0610 hub, 0bda:8153 gigE, 05e3:0743 card reader | Network good, usb ports good, card reader good | |
USB-C combo hub (network, card slots, usb ports) | generic | 05e3:0612 hub, 0bda:8153 realtek gigE | Network good, usb ports fail, card reader fail | |
5-1 USB-C hub | from aliexpress | 05e3:0626 hub | HDMI, Network, USB-3, USB-C PD good | Might need changing orientation or USB-C cable |
Yubikey original | Yubico | 1050:0010 | good | |
4 Port USB 3 NIC | Delock 62966 | good | 4 individually controllable Gigabit Ethernet Ports. Consider using it with own power supply | |
USB-2 Fast Ethernet adapter | Realtek RTL8152 | 0bda:8152 | good | |
USB 3 to Gigabit Ethernet Adapter | Pluggable USB 3.0 to Ethernet Gigabit (ASIX AX88179 chipset) | 0b95:1790 | good |
USB C alternate mode DP
Note that only USB C alternate mode Display Port will pass video. Any HDMI, DVI or VGA port must be converted internally by the device from Display Port. Or the device won't work for video.
Type | Make/Model | Hardware IDs | Result | Notes |
---|---|---|---|---|
USB-C to HDMI adapter 201018 | Cable Matters | good | Tested up to 1080p30, audio works | |
USB-C to HDMI adapter | generic | good | Tested up to 4k60 | |
USB-C to DP Adapter | OrxnQ | good | Advertises support for 4K@60Hz, tested up to 1080p | |
USB-C HDMI adapter (DP-alt mode) | QGeeM | good | Manjaro 2020-01-25 | |
USB-C combo hub (HDMI, network, card slots, USB ports) | generic | fail | ||
USB-C combo hub (HDMI, VGA, Ethernet, card slots, USB 2 & 3 | Powlaken | 05e3:0610 0bda:8153 | USB, Power, Ethernet and SD good, HDMI and VGA fail | |
USB-C Dock (HDMI, VGA, Ethernet, microSD/SD card slots, 2 USB 3 Ports, 1 USB-C Port, USB-Power Passthru | Digitus DA-70865 | USB, Ethernet and MicroSD/SD good, video crashes System (fail). | Tested on Manjaro w/ Kernel 5.5. You have to turn the USB-C connector upside down for it to work. Video seems to be a driver issue. | |
USB-C Dock (HDMI, VGA, Ethernet, microSD/SD card slots, 2 USB 3 Ports, 1 USB-C Port, USB-Power pass-through) | generic | Ethernet and MicroSD/SD good, USB fail, video up to 1080p. | https://forum.pine64.org/showthread.php?tid=8728 | |
USB-C Dock (DP, HDMI, 1Gbps Ethernet, SD card slot, 2 USB 3 Ports, USB-C power in port | goFanco | DP, Ethernet & USB good, (HDMI & SD card untested). Video tested good to 1080p | Tested on default Debian | |
USB-C Dock (HDMI, USB 3.0 x 2, USB-C PD Pass Thru Power Port Up to 100W, SD/TF Card Reader | Hiearcool 7-in-1 | HDMI, USB, Power Port good, SD/TF Reader fail | Default Debian | |
USB-C 3.0 Multi-Port Hub (HDMI, USB 3.0 x 1, USB-C charge only) | Linden LITCAD17 | HDMI and USB good, Power Port fail | Default Debian & ayufan Ubuntu | |
USB-C to DP adapter | Nekteck | 04b4:5210 | good | Shows up as "Cypress Semiconductor Corp. Billboard Device" in lsusb and dmesg output. Works in latest Manjaro (as of January 26, 2020) with no issues. |
USB-C to HDMI adapter | MHL TH002 | good | Tested at 1080p@60 | |
USB-C combo hub (USB-C power, HDMI, 2xUSB, 1xUSB-C(no power)) | Baseus | good |
Other hardware
Type | Make/Model | Hardware IDs | Result | Notes |
---|---|---|---|---|
Bluetooth Mouse | HP Z5000 | E5C13AA | good | |
Bluetooth Mouse | Logitech Triathlon M720 | good | ||
Bluetooth Mouse | Logitech Ultra-Thin Touch Mouse | good | Detects battery level as "keyboard" | |
Bluetooth Mouse | Logitech MX Anywhere 2 | good | ||
Bluetooth Mouse | Logitech M535 | 910-004432 | good | |
Bluetooth Mouse | Microsoft Bluetooth Mouse | RJN-00002 | good | |
Bluetooth Mouse | Fenifox low profile | MX106-Black | good | |
Bluetooth Speaker | Ivation Acoustix | good | Use audio sink profile | |
Headphone | Sony WH-1000XM2 | good* | Needs pulseaudio-module-bluetooth. *Recording untested. | |
USB charging cable | - | - | good | Got the cable a while back so may not be identical to current product |
USB Audio & Bluetooth Headset | Sony SBH90C | good | Works well connected via USB Type-C and Bluetooth. | |
SD Card | Samsung Evo Select 512GB | MB-ME512GA/AM | good | |
SD Card | Samsung Evo Plus 64GB | good | Hdparm tested 44MBps read speeds | |
SD Card | Sandisk Ultra 400GB | good | Works fine as a storage extension. Mounted for pictures, etc. |