Wifi Remote I2c

Quick Start Guide

Make sure that the driver for USB/UART Programming/Console Adapter (PMPROG01) is properly install and the PC is detected it as Comm Port.
The USB/UART Bridge is base on Silicon Lab CP2012 chipset.
USB/UART Programming/Console Adapter (PMPROG01) driver can be Download here
Connect the USB/UART Programming/Console Adapter (PMPROG01) to the Wifi Remote I2c Device.

Termite Setup Screen

For windows system, you can use terminal emulator program Termite to configure the device.
Termite can be downloaded at http://www.compuphase.com/software_termite.htm
Make sure the 'Port' setting is refer to the USB/UART Programming/Console Adapter (PMPROG01)'s Comm Port.
Follow the setting according to the setup screen capture
Once Termite configuration is done, press 'OK' to save the setting.
On the Wifi Remote I2c Device, Press the configuration button to allow the device to go into configuration mode.

Input 'help' to show the command available for configuration.
To Set the PineA64 IP address in to the device, enter (we will be using IP address 192.168.0.230 as example)
server 192.168.0.230
To configure the Wifi AP SSID and Password, (eg SSID=TestingWifi and Password=12345 )
wifi TestingWifi 12345
The SSID and password are case sensitive. Please make sure it is input correctly.
Once configuration is done, type 'exit' to exit configuration mode and allow the device to reboot.