Difference between revisions of "Accessories Step by Step Guides"
Jump to navigation
Jump to search
| (4 intermediate revisions by 3 users not shown) | |||
| Line 4: | Line 4: | ||
==Acrylic Open Enclosure:== | ==Acrylic Open Enclosure:== | ||
*[http://files.pine64.org/doc/guide/PINE64_Acrylic_Open_Enclosure_Installation_Guide.pdf Step by Step Installation Guide] | *[http://files.pine64.org/doc/guide/PINE64_Acrylic_Open_Enclosure_Installation_Guide.pdf Step by Step Installation Guide] | ||
If you wish to stack two or more of these enclosures, the screws that serve as feet can be replaced by M8-1.25x16mm grub screws. | |||
<blockquote> | |||
1.25mm is the pitch between threads, and for the M8 (8mm outer diameter) that's the default pitch, and most are advertised as M8x16mm screws. 16mm is really the minimum workable length to catch both the bottom and top aluminium standoffs, with both washers and the acrylic sheet in between. It's workable, but if you can get 20mm it's probably for the best. | |||
</blockquote> | |||
Images: https://imgur.com/a/Zka1qfb | |||
==Simple 3D Printed Case by Harlandraka== | ==Simple 3D Printed Case by Harlandraka== | ||
*[http://www.thingiverse.com/thing:1831345 3D printing schematics] | *[http://www.thingiverse.com/thing:1831345 3D printing schematics] | ||
| Line 16: | Line 25: | ||
==Real Time Clock (RTC) battery holder (CR-2032 Coin Cell battery type):== | ==Real Time Clock (RTC) battery holder (CR-2032 Coin Cell battery type):== | ||
*[http://files.pine64.org/doc/guide/PINE64_RTC_Backup_Battery_CR2032_Installation_Guide.pdf Step by Step Installation Guide] | *[http://files.pine64.org/doc/guide/PINE64_RTC_Backup_Battery_CR2032_Installation_Guide.pdf Step by Step Installation Guide] | ||
[[Category:PINE A64]][[Category:Guide]] | |||
Latest revision as of 16:22, 20 February 2023
Accessories Step by Step Guides
Wifi/Bluetooth module:
Acrylic Open Enclosure:
If you wish to stack two or more of these enclosures, the screws that serve as feet can be replaced by M8-1.25x16mm grub screws.
1.25mm is the pitch between threads, and for the M8 (8mm outer diameter) that's the default pitch, and most are advertised as M8x16mm screws. 16mm is really the minimum workable length to catch both the bottom and top aluminium standoffs, with both washers and the acrylic sheet in between. It's workable, but if you can get 20mm it's probably for the best.
Images: https://imgur.com/a/Zka1qfb